Wiring loom basic set MP25

Basic wiring loom for the MP25 ECU. The basic wiring loom contains all the wires in reliable covers that are needed to make a complete wiring. On one side, the pins are already connected at the ends of each wire to ensure easy installation.
All that remains to be done is to install the connectors, connect them to each component, and route the wires to the desired location for the ECU. Then cut the wires to the correct length and attach the main connector. The main connector is not included in this kit, but can be purchased separately. This basic wiring loom includes:

• Lambda 1
• Injection (type depends on your engine)
• Ignition (type depends on your engine)
• Water temperature
• Air temperature
• TPS (Throttle Position Sensor)
• Map (inlet/pressure air)
• Crank sensor
• Extra wire set MP25

In the Engine Configuration section, select the number of cylinders and whether you are looking for direct ignition or phased injections.